TECHNICAL INFORMATION
73
87-900-968-01(C)
TURBO-V 2K-G OUTLINE
The following figure shows the Turbo-V 2K-G outlines (dimensions are in mm [inches]).
INTERCONNECTIONS
The following paragraphs describe the Turbo-V
2K-G interconnections.
J1 – REMOTE I/O
At power-on the controller goes into “Remote I/O”
mode, even if it was in “Serial” mode before
power-down.
This connector carries all the input and output sig-
nals to remote control the Turbo-V 2K-G.
It is a 15-pins D type connector; the available sig-
nals are detailed in the table, the following para-
graphs describe the signal characteristics and use.
PIN N.
SIGNAL NAME
INPUT/
OUTPUT
ISOLATION
1 START/STOP
(+)
IN Optocoupled
2 START/STOP
(-)
IN Optocoupled
3 INTERLOCK
(+)
IN Optocoupled
4 INTERLOCK
(-)
IN Optocoupled
5
SPEED SETTING (+)
IN
Optocoupled
6 FAULT
COMMOMN OUT Relay
7
SOFT START (+)
IN
Optocoupled
8 SET
POINT
OUT Relay
9 +24
Vdc
OUT Transformer
10 PURGE
(+)
IN Optocoupled
11 SET
POINT
OUT
Relay
12 VENT
(+)
IN Optocoupled
13 FAULT
N.O.
OUT
Relay
14 ANALOG
OUTPUT OUT Optocoupled
15 GROUND
OUT Transformer
