Hurricane F-530
with leading wheel
10
5.2 Putting into operation.
The machine may be delivered without engine fillings (in dependence on different
national regulations)!
First thoroughly read the instruction for engine use! You can prevent a possible
damage to the engine.
1. Check oil volume in the engine and/or fill the engine with the prescribed oil grade and
volume. Fill the tank with the prescribed amount and type of petrol.
2. Move the accelerator lever into the front position (
„CHOKE“
). Start the engine by
pulling on the manual starter (instructions for starting see guidelines for engine use).
3. Let the new or cold engine running on choke for about 30 seconds (accelerator lever in the
„CHOKE“
position), and then move the accelerator lever into the position
„MAX“
. In
this position let the engine running for about 30 seconds.
Do not leave the machine alone when doing this!
5.3 Starting the cutting blade.
When starting the engine, the two levers on the handlebars must be in the off
position.
1. Start the engine while adhering to instructions presented in the operating manual for
engine use.
2. Set-up maximum engine revolutions by using the accelerator lever in the right part of the
handlebars crossbar. (Should the engine be cold, let it warm up at maximum revolutions
for about 1 minute).
3. Grasp the left handlebar grip with your left hand. Then slowly press the cutting blade
drive clutch lever on the right handlebar grip with your right hand.
Press the lever slowly up to about two thirds of the stroke so that the cutting blade
can start rotating and the engine does not stall
.
Figure 2: Machine assembly
1
2
3
4
5
6
7
8
6
