Hurricane F-530
with leading wheel
13
might damage the machine. If these cannot be removed, avoid working in such
places.
Working width has to be at all times accommodated to stand density!
If possible, do not use the machine on wet grass. Remember that the terrain you are
moving on must always be safe. Walk (never run) at work. Be careful especially
when changing the machine direction on slopes. Do not cut on steep slopes. When
accidentally falling, immediately release your hold on the machine.
5.6.2 Adjustment of cutting height of the machine with leading wheel
The slide shoe was replaced by a simple leading wheel on the machines of this new
generation. The machine became more controllable thanks to the leading wheel. The height adjustment
in two positions was preserved from the previous generation and it is now made with a spacing tube
put on the pin of the wheel hinge (see the positions on the picture below). The wheel can be locked
against side movement with an auxiliary safety pin when mowing on a slope (movement along the
contour lines is recommended). If you use the machine on flat areas or gentle slopes, store the pin with
the safety stirrup or put it on a place on the machine protected from the cut stand.
Upper position- height of the blade above the
ground approx. 9 cm
Lower position - height of the blade above the
ground approx. 6 cm
5.6.3 Adjustment of cutting height of the machine with slide shoe
The slide shoe may be purchased as accessory equipment under the ord. number
4205
.
The cutting height is initially set in the position for higher stubble (approx. 8 cm). This
position is intended for dense, tall stands and uneven terrains. If you are going to cut lower
stands (up to 15 cm) and on the areas without terrain unevenness, it is possible to set the slide
Pin with retaining ring for
axial locking of the wheel
Pin with safety stirrup for
side locking of the wheel
Spacing tube for height
adjustment of the wheel
Wheel hinge with wheel
Leading wheel arm
Put the
spacing tube
between the
leading
wheel arm
and the
wheel hinge.
Put the
spacing tube
above the
leading
wheel arm.
