Hurricane F-530
with leading wheel
9
5 Instructions for use.
5.1 Machine assembly.
Ask your dealer to provide unpackaging of the machine and briefing in machine
operation. Grip points for unpacking from the box: blade cover in the front, “U” tube of the
machine frame at the back.
If you assemble the machine yourself, please follow the instruction below:
Note: the washer size (e.g.
∅
8.4 mm) is always to be understood the diameter of the washer
opening.
1. Take the machine out of the box and all parts from their packing.
2. Turn the handlebars so that the handrails point to the rear of the machine. Attach the
handlebars (1) to the frame at a satisfactory height by means of bolts with square head (2),
washers
∅
8.4 mm (3) and plastic rosettes with female thread (4). Fasten the bowden cables
from the sheet metal levers and the accelerator lever to the handlebar by means of plastic
tightening tapes (5). Unloose two M8 bolts (6) holding the leading wheel (7) on the blade
cover and tilt the leading wheel down. Screw on two M8 bolts (8) with safety washers (9) into
the holes in the leading wheel frame. Now tighten all four bolts (6+8).
Figure 1: Mulcher
Hurricane
F-530
Travel wheels
Engine
Handlebars
Lever of blade drive
clutch with brake
Accelerator lever
(adjustment of engine
revolutions)
Lever of wheel
drive clutch
Plastic rosette for
adjustment of
handlebars height
Blade cover
Starter handle
Leading wheel – front handle (i.e. for
lifting of the machine, etc.)
Rear spots for
holding the
machine (for
driving, lifting or
loading)
Front lifting
cover
