Vari F-530.1, Instructions For Use Manual, Page: 25 / 41

F-530.1
25
b) Take out the split pin and screw off the slotted nut by using spanner No. 24. Remove the
wheel from the axis.
c) Clean the wheel hub inside, wheel hub flange with balls and free wheel from impurities
and old grease.
d) Fill the hub inside with new grease (e.g. for water pumps) lubricating at the same time
also the flange with balls and free wheel surfaces.
e) Slide the free wheel on the wheel axis. The pin driven into the wheel axis must lean
against the inclined surface on the free wheel (see Fig. 13). Put the wheel onto the axis,
screw the nut to the stop; then release it by one split pin groove and secure the connection
with a new split pin. The wheel must freely turn with no great axial clearance.
f) Check of correct free wheel assembly: Press the machine travel gear clutch lever, turn the
driving wheel by hand in the direction of forward travel. The free wheel must be clicking.
Figure 13: Free wheel (on the left wheel)
6.10 Storage
1. Prior to a longer storage, clean the machine from all impurities, debris and plant residues.
Repair the damaged places on the painted machine parts, particularly inside the knife
casing.
2. Conserve the mowing knife if the machine is to be put out of operation for a longer time.
3. Prevent the access of unauthorized persons to the machine.
4. Protect the machine from weather impacts; don’t use the air-tight protection due to a
possible increased corrosion under it.
6.11 Liquidation of packaging and machine after service life
expiration
After unpacking the machine, you are obliged to provide for the liquidation of packaging
with using the secondary raw-materials according to Waste Law No. 185/2001 Gaz. (and its
possible further amendments) and with respect to the decrees of local town or municipal
authorities.
Split pin
Slotted nut M16
Washer 17 mm
Wheel3.50-8“
Free wheel
Pin
Wheel axis