Vari F-530.1, Instructions For Use Manual, Page: 15 / 41

F-530.1
15
handrails). The casing space will do itself a partial clearance of excessive grass matter.
Then drive the machine against the stand again (see chapter 5.4).

Be very careful while driving in reverse with the machine!
c) Engine loosing speed and stalling : release the both levers on the handlebars, lift the
machine front part by pushing down on the handlebars and drive a bit in reverse. Clear
the mowing knife casing space and spread the cut grass across the ground. Start the
engine, switch on the knife drive (see chapter 5.3) and once again drive the machine
against the stand (see chapter 5.4).

Engine must always be switched off when clearing the knife casing space.

Tilt the machine always only backwards on the handlebars. Be very careful
while moving in the space beneath the lifted machine! Secure the machine
against motion!

Be very careful while cleaning the space beneath the casing. Mowing knife
blades are sharp. Your hands should be wearing protective gloves or you can
also use a fitted piece of branch etc.
5.6.3 Arrestment of guide wheel suspensions
In order to better guide the machine while driving along the countour line on slope, the
susoensions of guide wheels can be arrested in the position which is parallel to the
longitudinal axis of the machine. Insert the safety lock pins into holes in wheel suspension
bushes on the frame of guide wheels and clap the locks on the pins in. If not using the
arrestment, place the pins with locks onto an oval partition on the machine frame rear part.
Figure 5: Arrestment of guide wheels
5.7 Machine accessories
5.7.1 Slide shoe and its assembly
Slide shoe can be used instead of guide wheels to guide the machine in uneven
terrains. After you have dismounted the guide wheels (reverse procedure as in chapter
5.1, paragraph 4), mount the slide shoes as follows:
1. Insert draw bars which are part of the slide shoe into draw bar bushes on the knife
casing and arrest them by using the pins with locks.
Pin with the lock
Guide wheel
Hole in the wheel suspension bush on
the frame of guide
wheels and in the
wheel suspension