Vari Lite VLX3, User Manual

Page: 54 / 98

VARI
❋
LITE - VLX3 W
ASH
L
UMINAIRE
U
SER
’
S
M
ANUAL
38 17 December 2012 02.9703.0001 A
Control Channel Functions
Used to set different modes, parameters, and functions of the VLX3 Wash Luminaire via the control
console. Set control channel value for desired action. Hold value for at least 3 seconds.
Set control channel value to 0 without any scaling. Discrete values must be used; not manual controls
such as faders or encoders (see chart below for values).
To use control channel functions:
Step 1. Select an action to be sent.
Step 2. Set control channel value for desired action (for example, 84 for reset). Hold value for at
least 3 seconds (unless noted with a "#" in Mode 2).
Step 3. Set control channel value to zero. (This must occur without any scaling values. Action will
be voided if other values are detected between action value and zero.)
Note: A numerical keypad is required for sending values. An encoder or fader does not allow for a
quick value change, which is required to effect the control functions. However, the encoders on some
consoles include discreet value capability.
Control Channel Functions - Mode 1
Table 3-5: Control Channel Functions - Mode 1
DMX Channel Control Channel Function Control Channel DMX Value
23
Default Setting on Console 0
Display On / Off
3 - 4
Reset All to Defaults**
5 - 7
Quiet Mode
†
11 - 13
Level Light Mode
†
14 - 16
Constant Fans Mode
†
17 - 19
Normal Mode
†
20 - 22
Dimmer Curve LINEAR
†
31 - 32
Dimmer Curve SQUARE LAW
†
34 - 35
Full Luminaire Reset 81 - 87
Color Calibration OFF
†
116 - 117
Color Calibration ON
†
118 - 120
Manual Color Adjust ENABLE† 121 - 122
Manual Color Adjust STORE† 124 - 125
Notes:
** When resetting to defaults, the following will be enabled on the luminaire:
• Normal Mode
• Dimmer Curve SQUARE LAW
• Color Calibration ON
† These settings require the Command Lock in Menu to be set to OFF in order to change on Control Chan-
nel. Resetting to defaults will turn Command Lock OFF.