Vanward GD4819S, Assembly, Use And Care Manual

Page: 20 / 28

20
LEAK TEST BEFORE CONTINUING.
5. DO NOT REMOVE THE GREASE TRAY IF THE GRILL HASN’T COMPLETELY
COOLED.
6. CLOSE ALL CONTROL KNOBS AND THE TANK VALVE WHEN THE GRILL IS NOT IN
USE.
7. NEVER MOVE THE GRILL WHILE IN USE OR STILL HOT.
8. PUSH THE GRILL FORWARD. DO NOT PULL WHEN MOVING IT.
9. DISCONNECTED THE TANK IN STORAGE OR BEING TRANSPORTED MUST HAVE A
SAFETY CAP INSTALLED. DO NOT STORE A GAS TANK IN ENCLOSED SPACES
LIKE CARPORT, COVERED PATIO, PORCH, GARAGE OR OTHER BUILDINGS.
10. NEVER LEAVE A GAS TANK IN A RECREATIONAL VEHICLE OR BOAT WHICH MAY
BECOME OVERHEATED BY THE SUN.
11. DO NOT STORE GAS TANK IN OR NEAR AN AREA WHERE CHILDREN PLAY.
12. DISCONNECTED THE TANK AND REMOVE FROM THE GRILL IF THE GRILL IS
STORED INDOORS.
13. ANY OTHER PROBLEM, SEE “TROUBLESHOOTING” OR CONTACT OUR SERVICE
CENTER.
INSTALLER FINALCHECK LIST
ˆ
At least 1m clearance maintained from combustible constructions to the sides and back
of this grill.
ˆ
There is no unprotected combustible construction over the grill.
ˆ
All internal packaging removed.
ˆ
Burners are sitting properly on orifices.
ˆ Knobs turn freely.
ˆ Unit tested and free of leaks.
ˆ User informed of gas supply shut off valve location.
ˆ Make sure that the hose is not in contact with parts of the BBQ becoming hot and that the
hose don’t have any constraint applying on it and that it is not twisted
GRILL LIGHTING INSTRUCTIONS
„
WARNING: IMPORTANT!
„
BEFORE LIGHTING
Finally inspect the gas supply hose before turning the gas “ON”. If there is evidence of cuts,
wear, or abrasion, it must be replaced before use, the replacement hose assembly shall be
that specified by the manufacturer.
VERY IMPORTANT: ALWAYS INSPECT THE HOSE BEFORE EACH USE OF THIS
GRILL.
BEFORE IGNITING THE GRILL, UNSCREW THE BLACK ELECTRONIC IGNITION
BUTTON, AND PLACE AN AA BATTERY INSIDE IT, THEN TIGHTEN IT ( REMEMBER TO
REPLACE THE BATTERY WHEN NO SPARK COMES OUT).