18
c. THE INLET OF THE PRESSURE REGULATOR SHALL BE FITTED TO CONNECT THE
TYPE I CONNECTION OF THE TANK VALVE.
1. Make sure tank valve is in its full off position (turn clockwise to stop).
2. Check tank valve to assure it has proper external male threads.
3. Make sure all burner knobs are in their off position.
4. Remove the protective cap from the tank valve, Always use cap and strap supplied with
valve.
5. Inspect valve connection port and regulator assembly. Look for any damage or debris.
Remove any debris. Inspect hose for damage. Never attempt to use damaged or
plugged equipment. Contact your local gas dealer for repair.
6. When connect regulator assembly to the valve, hand tighten nut clockwise to a positive
stop. Do not use a wrench to tighten. Use of a wrench may damage quick coupling nut
and result in a hazardous condition.
7. Open tank valve fully (counterclockwise). Use a soapy water solution to check all
connections for leaks before attempting to light grill. If a leak is found, turn tank valve off
and do not use grill until a local gas dealer can make repairs.
！！！
WARNING
！！！
1. Never insert any foreign objects into the valve outlet. It may damage the valve and
cause leak, leaking gas may result in fire, explosion, heavy body injury, or even
death.
2. Do not connect this grill to the self-contained the gas system of a motor home or
camper trailer.
3. Do not use the grill until leak tested.
4. Stop and call the fire department if any leak detected.
5. If you cannot stop a gas leak, close the gas tank valve IMMEDIATELY, call the gas
supplier or the fire department.
！！！
DANGER
！！！
1. NEVER store a spare gas tank under or near grill or in an enclosed area.
2. NEVER fill the tank beyond 80% full. An overfilled spare gas tank is dangerous
because surplus gas may leak from safety relief valve. The safety relief valve on a
gas tank could activate to release gas and cause a fire.
3. The spare gas tank must have safety caps installed on the gas tank outlet.
4. If any gas leak found on the spare gas tank, immediately go away from it and call
the fire department.
5. Keep the gas cylinder away from any source of ignition when changing gas
cylinder.
VERY IMPORTANT: DISCONNECTED THE TANK WHEN THIS GRILL IS NOT IN USE.
To disconnect the gas tank:
1. Turn all the knobs off.
2. Turn the tank valve off fully (turn clockwise to stop).
3. Detach the regulator assembly from tank valve by turning the quick coupling nut
counterclockwise.
Summary of Contents for GD4819S
Page 4: ...4 2 Parts Diagram ...
