RJ45 Connector for Audio/Video
To build your own A/V RJ45 connectors, please follow the
PIN-OUTS shown below.
NOTE:
TPT1040 Wiring
•
CAT5e network cable with RJ45 connectors.
•
Romex or equivalent 120-220VAC power supply*
•
Each TPT1040 may also have up to four A/V cables
using CAT5e with RJ45 connectors and an A/V
Connector Cable – part number VDA-0176 shown above
– on the A/V end.
*See the
TPT1040-INSTALL-16
sheet
VDA-0176 A/V Connector Cable
The
TPT1040-INSTALL-16
kit ships with one VDA-0176 A/V
connector cable. Additional cables may be purchased from
Vantage Controls. This cable connector is designed to connect
directly to the A/V equipment using the RCA connectors. Use
a straight through RJ45 (female) coupler allowing the installer
to run longer CAT5e wire runs with male, RJ45 type
connectors to the TPT1040 and the VDA-0176 connector
cable. A/V wire runs should not exceed 200ft. Please see the
TPT1040-INSTALL-16
install sheet for details.
SD Memory Card
For most applications the built-in memory will be sufficient.
However, the TPT1040 allows an SD Memory card to be
inserted if it is anticipated that the design will require more
than the default memory. Erase the current program on the
TPT1040 first (see
TPT1040 System Screen
above).
NOTE: To avoid possible configuration issues, power down the
TPT1040 when inserting or removing the SD Memory Card.
Reprogram the TPT1040 after inserting an SD Memory card.
Connection Status Indicator
In the Configuration screens mentioned earlier, notice the
round highlighted indicator in the upper right hand corner. This
indicator changes appearance to indicate the connection
status of the TPT1040. Use this indicator to help trouble shoot
issues if the screen appears to have connection issues. The
indicator changes colors as indicated below.
Indicator
Color
Connection Status
Green
Connected and properly configured
Amber
Connected to controller but not properly
configured on the controller
Grey
Not connected to a controller
Red
Ethernet disconnected
Trouble Shooting Tips
Problem
Solution
TPT1040
Continually
Reboots
The design application
may
be corrupted.
Touch toward the outside edge of the screen,
the instant the loading spinner displays. A
message will pop-up asking,
“Do you wish to
start up without loading configuration?”
To
abort the design application from loading
click OK. A new design application may now
be downloaded to the screen from Design
Center.
Can’t Erase
The Screen
From The
Configure
System
Menu
From the Boot Loader Screen (see
Reset
above) press the hard buttons in this order:
LEFT & RIGHT (simultaneously)
-then-
LEFT | RIGHT | RIGHT | LEFT
When the screen is reset it should be back to
factory settings
39755 / InFusion compatible
©Vantage
