![background image](http://html1.mh-extra.com/html/allo-remotecontrol/telcoma/telcoma_instructions_2903725001.webp)
INSTRUCTIONS
Preliminary operations:
1.
Set a code, as desired, in the FOX remote controls.
2.
Connect an antenna tuned to the antenna terminal on the receiver. Alternatively,
diminishing the receiver specifications, a piece of wire approx. 20 cm long may be
connected.
3.
Once the receiver has been connected to the control unit or the necessary connections
on to the terminal board have been completed, switch on.
4.
As soon as the receiver is powered, it carries out an internal test, shown by LED L2
coming on for 3 seconds
.
Self-memorisation:
1.
Upon pressing key P1 for an instant the relative led will blink 5 times
2.
Within this period of time, transmit with the radio control required for use
3.
Fixed indicator lights lasting about 3 seconds indicate that the code has been
successfully stored
4.
Immediately after this the led starts blinking again, waiting for a new radio control
signal to be memorised; if it receives none after blinking another 5 - Fixed indicator
lights lasting about 3 seconds indicate that the code has been successfully stored. -
Immediately after this the led starts blinking again, waiting for a new radio control
signal to be memorised; if it receives none after blinking another 5 times, the receiver
automatically exits from the programming stage
TELCOMA
Visit our website: www.Alloremotecontrol.com