Vansco VMM3120, User Manual

Page: 18 / 92

8 VMM3120
Quick Start
1. Connect the Controller I/O harness to the VMM3120 multiplexing module.
2. Connect the Controller I/O harness to the controller I/O board connectors.
3. Connect the evaluation kit power/CAN harness to the controller I/O board’s
JP3 connector.
4. Do not connect the power wire (RED) from the evaluation kit power/CAN
harness to the power supply (+) terminal at this time.
5. Connect the ground wire (BLACK) from the evaluation kit power/CAN
harness to the power supply (-) terminal.
6. Connect the CAN connector from the evaluation kit power/CAN harness to
the corresponding mating connector and harness on the DLA.
Note: Do not proceed to the next step before the DLA drivers have been
installed. See Install the Data Link Adapter Driver Software on page 6.
7. Connect the DLA to a personal computer via the USB port.
2.4.1. Power Up the Development System
To power up the VMM3120 multiplexing module:
1. Ensure that all controller I/O board digital inputs, jumpers, and dip switches
are properly configured for your module type. Refer to the
Controller I/O
Board Reference Manual for further details.
2. Ensure that the power wire (RED) on the controller I/O board is not
connected to the power supply (refer to the Controller I/O Board Reference
Manual for details).
3. Turn the power supply on.
4. If using a variable power supply, set the voltage to a value between 10 to 28 V
DC.
5. Turn the power supply off.
6. Connect the power wire (RED) on the connector I/O board to the power
supply.
7. Turn the power supply on.
Note: If an input e.g. INPUT_1 is configured as a power control input, you
must turn on the corresponding digital input switch on the controller I/O board
(e.g. Digital Input 1). Refer to the
Controller I/O Board Reference Manual for
further details.