Van's Aircraft RV 12iS, Production Acceptance Procedures

Page: 17 / 50

Revision: 2.3 Date: 10/30/20
G5-2

Note current altitude indication:_________

Tape-over one of the static ports with electrical tape, fully push-in syringe plunger and use
modeling clay to hook-up syringe & vacuum hose to the other static port, use syringe to draw-
out air from static system. Look for altitude indication on EFIS, draw syringe out until 1,200 ft
above current altitude indicates, stop drawing-out.
Start stopwatch when EFIS indicates 1000 ft above field elevation.
Note the altitude: _______ ft after one minute.

Maximum allowable static system leak rate is 100 ft in one minute.
NOTE: If leakage is excessive, inspect the modeling clay seal before inspecting other
static system components. Inspect and repair or replace any faulty static system
components as necessary
Configure your EFIS to display AOA information using the Dynon or Garmin AOA setup
instructions, as necessary. Also refer to the Van’s Aircraft downloadable “Read Me” file that
pertains to your EFIS system for additional information.
AOA calibration must be done in flight, take all necessary precautions.
Section G5 checks completed by:
Printed Name/Title Aircraft Serial Number
Signature Date