VANPOWERS URBANEASE Series, User Manual, Page: 25 / 61

Disc rotor
Align the rotor with the brake caliper to center the rotor
between the brake pads, ensuring that the tire is also
centered. Insert the front axle from the opposite side of
the rotor. Note that the handle is on the same side as the
chain.
STEP TWO
Use a 15 mm open-end wrench to loosen screws and in
sequence, as shown in the figure, and remove the front fork
protector.
Please note that this accessory is only used to prevent
deformation of the front fork during transportation and is
not necessary for installing the bicycle.
04 Install the front wheel
STEP ONE
NOTICE!
After removing the brake pads, do not squeeze the brake
lever on the handlebar, as this can cause brake damage
that will not allow the bike to function properly! The brakes
should only be used after the front wheel is installed.
1 2
23
15
13
1
2