VANPOWERS URBANEASE Series, User Manual, Page: 24 / 61

After fastening the upper bracket, use a 4 mm Allen key
to remove the 2 screws at the bottom of the front fork.
Then, align the legs of the front fender with the installa-
tion holes at the bottom of the front fork, and re-tighten
the screws. You will need to turn the vehicle upside down before
installing the fenders.
01 Undo the fender screws on the inside of the front fork
with a 10 mm open-end wrench (as shown in the figure).
02 Check that the mudguard is correctly oriented, then
align the mudguard bracket and the front light mounting
bracket with the front fork screw holes.
03 After confirming that the mudguard and front light are
aligned with the screw holes, use a Phillips screwdriver to
rethread the screws to affix the front light and mudguard to
the front fork. Finally, tighten the screws with a 10 mm
open-end wrench.
03 Install the front fender and front light
STEP ONE STEP TWO
22
08
10
08
10
4mm