PURE BREEZE FUME HOOD
120V
25799 Jefferson Ave.
Murrieta, CA 92562
1-800-VANIMAN (826-4626)
www.vaniman.com
10370-11/21 PAGE 2
Page 2
PACKING LIST
1 - Pure Breeze Fume Hood
1 - Power Cord
1 - Wall Hanging Bracket
2 - Hood Skirt Sides
2 - Hood Skirt Centers
4 - Hood Skirt Corners
3 - Hanging Eye Bolts
3 - Eye Bolt Nuts
3 - Eye Bolt Washers
3 - Wall Mounting Screws
2 - Rubber Feet with adhesive
16 - Hood Assembly Screws (6-32)
Components installed at factory
1 - Wall Hanging Bracket
6 - Hood Mounting Thumb Screws
2 - Hood Mounting Star Lock Nuts
ASSEMBLY AND INSTALLATION INSTRUCTIONS
1. To remove the
Fume Hood
from the box, open the box flaps, remove the loose items, stand the box
upright, and slide the unit out. Remove the plastic bag from the unit and check all parts against the
packing list.
2. Laying the Fume Hood flat with the control panel facing up, unlatch the door from the left side and
open. Remove all filters from the unit and remove the plastic bags covering each filter. The plastic
bags must be removed for the unit to work. Place the filters back into the unit in the same order they
were removed starting with the Pre-Filter (P/N 97021) on bottom, the Secondary Filter (P/N 97022)
next, then the Charcoal Odor (P/N 97023) filter last. The HEPA filter (97024) should be repalced above
the motor compartment.
3.
The
Hood Skirt
can be configured to meet the mounting area constriants by just leaving coresponding
components out when assembling (see Figure A on next page). For example: If the desired position
is near a corner using the wall mount, simply leave off the skirt parts from the back and adjacent wall
side. To install the hood skirt parts:
IMPORTANT SERVICE INFORMATION:
SAVE SHIPPING BOX AND FOAM FOR FUTURE
SERVICE. SHIPPING WITHOUT PROPER FOAM
MAY CAUSE DAMAGE TO UNIT
