Vanguard 6500 PLUS, Installation Manual

Page: 69 / 102

Installation 2-61
Replacing Processor Card Components
Replacing FLASH Modules
Introduction You can replace a FLASH module on a 6500
PLUS
processor card. The location of a
FLASH module is shown in Figure 2-17.
Caution
Use proper handling and grounding precautions, including the use of an anti-static
grounding strap, whenever you handle a card
Replacement
Procedure
Follow these steps to replace a FLASH module (see Figure 2-22):
Step Action
1 Remove the card from the nest or enclosure.
You might have to wiggle the card until the header pins disengage
from the socket on the card.
2 a) Loosen and remove the four screws that hold the FLASH
module to the processor card.
b) Carefully lift the FLASH module from the 6500
PLUS
processor
card.
3
Using the old module as a guide, insert the header pins of the new
module.
4 Place the new module on the 6500
PLUS
processor card.
5
Insert the header pins into the socket. Seat the pins firmly into the
socket. Do not bend them.
6 Use four screws to secure the FLASH module to the 6500
PLUS
processor card as shown. Do not overtighten the screws.