Swift1925Z Aura LED Moving Head Beam Wash Light User Manual Swift1925Z Aura LED Moving Head Beam Wash Light User Manual
3. Home Position Adjust
In the main functions, hold
Enter
button for at least 3 seconds into offset mode, use
DOWN
and
UP
button up to chose Pan Offset, Tilt Offset or Zoom Offset, pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to adjust the home position of
the Pan, Tilt or Zoom, Once the position has been selected, press the
ENTER
button to
setup, to go back to the functions without any change press the
MENU
button again. Hold
and press the
MENU
button about one second or wait for one minute to exit the menu
mode.
4. Control By Universal DMX Controller
1.
If you using a controller with 5 pins DMX output, you need to use a 5 to 3 pin
adapter‐cable.
2.
The last units DMX cable has to be terminated with a 120 ohm 1/4W resistor between
pin 2(DMX‐) and pin 3(DMX+) of a 3‐pin XLR‐plug and plug it in the DMX‐output of the
last unit.
3.
Connect the unit together in a `daisy chain` by XLR plug from the output of the unit to
the input of the next unit. The cable can not branched or split to a `Y` cable. DMX 512
is a very high‐speed signal. Inadequate or damaged cables, soldered joints or corroded
connectors can easily distort the signal and shut down the system.
4.
The DMX output and input connectors are pass‐through to maintain the DMX circuit,
when one of the units’ power is disconnected.
5.
Each fixture unit needs to have an address set to receive the data sent by the controller.
The address number is between 0‐511 (usually 0 & 1 are equal to 1).
6.
The end of the DMX 512 system should be terminated to reduce signal errors.
7.
3 pin XLR connectors are more popular than 5 pin XLR.
3 pin XLR: Pin 1: GND, Pin 2: Negative signal (‐), Pin 3: Positive signal (+)
5 pin XLR: Pin 1: GND, Pin 2: Negative signal (‐), Pin 3: Positive signal (+),
Pin 4/Pin 5: Not used.
Ⅷ
ADDRESS SETTING AND DMX CHANNEL OPERATION
If you use a universal DMX controller to control the units, you have to set DMX address
from 1 to 512 so that the units can receive DMX signal.
Press
MENU
button to enter menu mode, select DMX Functions, press
ENTER
button to
confirm, use
UP
and
DOWN
button to select DMX Address, press
ENTER
button to
confirm, the present address will blink on the display, use
UP
and
DOWN
button to adjust
19
18
