V&P Scientific, Inc.
8
Technical Note 396C
PRODUCT MAINTENANCE
GENERAL PRODUCT CARE
When not in use, turn the power switch off.
Do not place the control unit in chambers with temperatures above 40
o
C.
To clean the stirrer, wipe down with a cloth and mild detergent followed by a water wipe.
Do not immerse
SpinVessel® Motor or Control in liquid
.
The motor of the VP 418SV-650FB-CC SpinVessel® is a stepper motor, 100-240 Volts, 50/60 Hz, CE compliant
SAFETY PRECAUTIONS
The use of motor controls, like that of all utilization of concentrated power, is potentially hazardous. The degree of
hazard can be greatly reduced by proper design, selection, installation, and use, but all hazards cannot be completely
eliminated.
The following safety precautions must be observed during all phases of installation, operation, service, and repair of
this motor control product. Failure to comply with these precautions or with specific warnings elsewhere in this
manual violates safety standards of design, manufacture and intended use of the products. V&P Scientific assumes
no liability for the customer’s failure to comply with safety requirements and practices.
WARNING
To avoid personnel injury caused by electrical shock, do not remove the cover
of the controller when the power is ON.
CAUTION
Do not disconnect motor during operation. Otherwise, over-current
breakdown may result.
WARRANTY
V&P Scientific, Inc. warrants this product to be free from defects in material and workmanship when used under
normal laboratory conditions for one year. This warranty begins from the date of delivery by V&P Scientific.
In the event this product fails under normal laboratory conditions within the specified period of time because of a
defect in material or workmanship, V&P Scientific will, at its option, repair or replace the product. Damage to the
product caused by user negligence is not covered.
This warranty is made in lieu of other warranties expressed or implied, including merchantability and fitness for a
particular purpose. V&P Scientific shall not be liable for loss or damages arising from the use of these products.
Please keep the special shipping carton in case the unit needs to be shipped back to V&P Scientific. Please contact
V&P Scientific for return authorization and shipping instructions.
If technical assistance is required, contact: V&P Scientific, Inc. at 858-455-0643 or
