www.vanco1.com
800.626.6445
18
7.2 IR Pass-through Control
The matrix switcher supports bi-directional IR pass-through, allowing the devices to be controlled by both
source and display ends. This section provides connection and switching examples to illustrate possible
configurations.
7.2.1 Control Local Input Device from Remote
The local input source device can be controlled from the remote receiver location.
•
Control local input device through IR OUT port
Example: Switch HDMI input 2 to HDBaseT output 3.
Connect an IR receiver to IR IN port on the receiver, then connect an IR emitter to the IR OUT 2 on the matrix
switcher. The third input source can be controlled through its corresponding IR output port. The connection
diagram shown as below:
•
Control local input device through IR ALL OUT port
The emitter can be connected to the IR ALL OUT port on matrix switcher to control all local input devices. In
this case, the IR receiver must be connected to the IR IN port on each connected HDBaseT receiver, as shown
in the diagram below:
