www.vanco1.com
800.626.6445
21
To control the matrix switcher from a remote location, please connect one or more PCs to the RS-232 ports
of HDBaseT receivers with the 3-pin to DB9 RS-232 Cables. The matrix switcher can be controlled by any one
of PCs, the connection diagram is shown as below:
8.1.2 Control the Matrix Switcher from Remote
Note: The command “RS232RCM[X]ON.” ([X]=0~3) needs to be sent to enable or disable this control mode.
For example, send the command “RS232RCM0ON.” to enable the remote-control mode for all HDBaseT
outputs, and send the command “RS232RCM0OFF.” to disable the remote-control mode for all HDBaseT
outputs. Please refer to the 8.3.1 System Control for more details.
To control a remote third-party device from local, first determine which HDBaseT receiver is connected to (1
in the diagram below). Next, connect a PC to the corresponding RS-232 port of matrix switcher with 3-pin to
DB9 RS-232 Cable, then connect a third-party device (e.g. projector) to the RS-232 port of the determined
HDBaseT receiver. The remote third-party device can be controlled by the local PC; the connection diagram is
shown as below:
8.1.3 Control the Remote Third-party Device from Local
