AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 6: MAINTENANCE
090012-OP_r0
PAGE - 91
1. Locate the engine dipstick handle [
H
] and
remove.
2. Wipe off the excess oil on the dipstick blade,
and replace the dipstick back into the engine
tube in order to get a clear level reading.
3. Remove the stick again, and observe where
the oil level shows at the gauge-end of the
stick.
The level should be somewhere within the
range shown on the stick [between
J
1
and
J
2
].
If the level shows low, replenish with the same
type of engine oil currently being used to
achieve a satisfactory level, by adding oil at
engine oil fill port [
C
].
If the engine is due for an oil change, or if operating
conditions require more frequent change intervals than
the normal routine maintenance schedule given in this
KEY
DESCRIPTION
KEY
DESCRIPTION
A
ENGINE TEMPERATURE SWITCH
F
ENGINE PRESSURE SWITCH
B
ENGINE AIR FILTER
G
ENGINE OIL FILTER
C
ENGINE OIL FILL PORT
H
ENGINE OIL DIPSTICK
D
FUEL FILTER
J
1
ENGINE OIL LOW LEVEL MARK
E
ENGINE OIL DRAIN: TUBE & OUTLET
J
2
ENGINE OIL HIGH LEVEL MARK
Figure 6-16: Engine Components
D
B
J
1
J
2
C
E
G
F
A
H
