10
FAS-402 Series Operating Instructions Ver. 4.06E
Caution
Do not place hands in the sealing area
With prolonged use, the sealing area will retain heat and become hot.
If you place your fingers in this area, there is a possibility of burns.
Pressing the foot switch will lower the seal lever and pressure is applied
to the seal area. Please be careful not to pinch your fingers to the
sealing area. When two or more operators are involved in the machine
operation, please pay extra attention to avoid accidents.
Warning
Do not use parts other than those specified
When replacing parts, always use only specified parts sold through
Van
der Stahl Scientific
.
We are n
ot responsible for malfunctions caused by
the use of unspecified parts.
Warning
If the power switch automatically turns to the OFF
position
If the power switch will automatically turn to the OFF position, there is
a possibility of malfunction of the machine such as short circuit.
Do not operate the machine until the cause of the shut down is
ascertained and the problem has been addressed.
Caution
Be careful of the vacuum nozzle
A vacuum nozzle comes out automatically in a few seconds after
finishing the operation. Please be careful of the moving nozzle.
If you bring your face or hands close to the sealing area, you can get
hurt with the nozzle. Also if the sealed pouch is left in the sealing area,
the nozzle can heart the packaging content. Please make sure to remove
the pouch when the lever is open.
Caution
Do not use in the following places
Do not operate the machine in the places with high humidity and/or
where the water/vapor can spill on the machine. The machine parts may
become rusted. There is a danger of electrocution and/or machine
malfunction due to the insulation failure.
The small particles can also cause the insulation failure, machine
malfunction as well as short circuit. Do not operate the machine in the
dusty locations or avoid packaging the powdery items.
