VAN DER ENDE Airmix G, Installation Manual

Page: 15 / 32

Van der Ende Groep · Aartsdijkweg 23, 2676 LE, Maasdijk · Tel. 0174 515050
IBAN NL71 RABO 0340341610 · KvK Den Haag 27230471 · Btw-nummer NL8000.78.378.B01 · info@vanderendegroep.nl · www.vanderendegroep.nl
Page 15 of 32
4.2.2 Installing the condensate plate and fan
After the Airmix housing has been suspended, the condensate drip tray and the fan can be attached
to it. Depending on the type of fan, it is best to prepare this first; see chapter 6. To attach the fan and
condensate plate correctly, go through the following steps:
-
make sure you have the proper tools and equipment:
Quantity Description
2 17mm open-ended wrench or socket wrench
-
make sure that the fan can be installed safely – get help if necessary;
-
what you will need for each Airmix:
Quantity Description No. in
Figure 10
Article no. VDEG
1 Fan 21 720034XX
1 Condensate drip plate 22 72005120
8 m10 self-locking nut 23 56016220
12 m10 washer 24 56019220
2 m10x25 bolt 25 56013230
2 m10 nut st vz 26 56015220
-
Figure 10);
-
attach the fan (21) to the Airmix housing by inserting it over the protruding M10 threads;
position the fan with the cable gland connection facing downward;
-
secure the fan to the upper six M10 threads with six M10 washers (24) and six M10 self-
locking nuts (23);
-
attach the condensate plate (22) to the Airmix housing by inserting it over the protruding M10
threads;
-
secure the condensate plate to the lower two M10 threads with two M10 washers (24) and
two M10 nuts (not self-locking nuts) (26);.
-
Secure the condensate plate to the fan with two M10x25 bolts (25), four M10 washers (24)
and two M10 self-locking nuts (23).
Figure 10 Installing the fan