www.valuehobby.com/js-40.html
Step9. With the aileron centered, tighten the screw
on the push rod connector.
Step10. Cut off the excess push rod.
Step11. Repeat steps 1 through 10 for the
remaining aileron servo.
Section3. Stabilizer and Elevator Installation
Step1. Remove the covering from the fuselage as
shown.
Step2. Slide the horizontal stabilizer into the slot in
the fuselage, with the leading edge pushed
forward in the slot. Center the stabilizer in the
opening by measuring the distance from the
fuselage to each tip. The stabilizer is aligned when
both measurements are identical.
Summary of Contents for screamer 40
Page 17: ...2016 07 11...
