Value Hobby screamer 40, Instruction Manual

Page: 7 / 17

www.valuehobby.com/js-40.html
Section1. Aileron Installation
Step1. Use the hobby knife to remove the covering
for the servo opening.
Step2. Place four hinges into the pre-cut slots in
the wing. Apply thin CA to the hinges. Make sure
the hinges are glued to the wing.
Step3. Slide the aileron and wing together. The gap
between the aileron and wing should be infinitely
small, approximately 1/41-inch.
Apply the thin CA to the hinges again. Make sure
the aileron is glued to the hinges.
Step4. Repeat steps 1 through 7 for remaining
aileron.
Section2. Aileron Servo & Linkage Installation
Step1. Prepare an aileron servo by installing servo
horn, grommets and brass eyelets.
Step2. Put the servo in position on the servo hatch,
and use a pen to trace outline of the servo.
(It is not necessary to position the servo horn in
the middle of the slot because the aileron only
needs a small control throw; you can move the
servo to the left a little.)
Step3. Use thin CA to glue the mounting blocks to
the servo hatch.