www.valuehobby.com/js-40.html
Step3 Check the distance from each stabilizer tip to
each wing tip. These measurements must also be
equal.
Step4 The last alignment step is making sure the
wing and stabilizer are parallel. If they are not,
lightly sand the opening in the fuselage for the
stabilizer until the stabilizer rests parallel to the
wing.
Step5 Use a pen to trace the outline of the fuselage
on the bottom and top of the stabilizer.
Step5. Remove the stabilizer from the fuselage,
and use hobby knife to remove the coverings along
the line drawn in the previous step.
Step6. Place the elevator joiner wire into the slot.
Summary of Contents for screamer 40
Page 17: ...2016 07 11...
