www.valuehobby.com/js-40.html
Step7. Apply the epoxy to the exposed area on the
bottom and top of the stabilizer, slide the stabilizer
back into the slot and double-check the alignment
of the stabilizer.
Step8. Insert the hinges into the elevator and apply
thin CA to the hinges.
Step9. Test fit the elevator and stabilizer together,
Mark on the elevator where the elevator joiner
wire will be insert.
Step10. Drill the hole on the elevator for the
elevator joiner wire.
Step11. Attach the elevator to the stabilizer
through the joiner wire and CA hinges.
Apply epoxy to the groove and holes for the joiner
wire, and apply thin CA to the hinges.
Summary of Contents for screamer 40
Page 17: ...2016 07 11...
