VALTIR EURO-ET END TERMINAL, Product Description Assembly Manual

Page: 20 / 28

Valtir.com 19 Revision D February 2023
Attaching Guardrail Extruder Head
1. Place the Guardrail Extruder Head (PN 995A) (PN 29G). over the end of the Anchor
Guardrail
Important:
The Guardrail Extruder Head (PN 995A) can be used on the left-
or right-hand shoulder/verge. Be sure the exit slot is on the field side, away
from traffic.
2. The Guardrail Extruder Head (PN 995A) should be pushed on the Anchor Guardrail (PN
29G) as far as it will go, while making sure th a t the end edge of the Anchor Guardrail (PN 29G)
is completely inside the Guardrail Extruder Head (PN 995A) and butting up against the
beginning of the bending slot inside the Guardrail Extruder Head (PN 995A).
3. The two Attachment Brackets of the Guardrail Extruder Head (PN 995A) have 3 holes in each
Bracket. Choose the hole in the Bracket that is closest to the predrilled hole in the HBA Top Post
1 (PN 33462A) while making sure that the edge of the Anchor Guardrail (PN 29G) is completely
inside the Guardrail Extruder Head (PN 995A).
Important:
The guide channels of the Guardrail Extruder Head (PN 995A)
should be approximately parallel to the ground.
4. Secure both top and bottom Attachment Brackets of the Guardrail Extruder Head (PN 995A) to
HBA Top Post 1 (PN 33462A) with a 10 mm diameter x 38 mm hex head bolt (PN 4261G) and a
10 mm flat washer (PN 4254G) under the bolt head. A 10 mm Fender Washer (PN 4255G)
and 10 mm lock washer (PN 4258G) are placed between the 10 mm hex nut (PN 6405G) and
the flange on the HBA Top Post 1 (PN 33462A) (see Figure 9).
Important:
There is no torque requirement for these bolts. They should be
tightened to a snug position. Do not over tighten these bolts.
Figure 9