VALTIR EURO-ET END TERMINAL, Product Description Assembly Manual

Page: 14 / 28

Valtir.com 13 Revision D February 2023
Attaching HBA ® Top Posts
Once the HBA
®
Bottom Posts (PN 33873A) are placed, the HBA
®
Top Posts can now be
attached.
Post 1
1. At Post No. 1, attach the HBA
®
Top Post 1 (PN 33462A) by aligning the holes of the post plates
(ears) on the Top and Bottom Posts.
Note:
The HBA
®
Top Post Plates (Ears) can be placed on either side of the HBA
®
Bottom
Post Plates (Ears).
2. Insert a 10 mm diameter x 51 mm hex head bolt (PN 6321G) through the 11 mm holes of the
post plates (ears) on the Top and Bottom Posts. The bolts should be positioned so the nuts are
on the inside of the post plates (ears) (see Figures 4 and 5).
3. Place a 10 mm flat washer (PN 4254G), and 10 mm lock washer (PN 4258G) under the 10
mm ex nut (PN 6405G) (see Figures 4 and 5).
4. Insert a 19 mm diameter x 64 mm hex head bolt (PN 3717G) through the 21 mm hole (on the
traffic side) of the post plates (ears) on the Top and Bottom Posts. The bolts should be positioned
so the nuts are on the inside of the post plates (ears) (see Figures 4 and 5).
5. Place a 19 mm flat washer (PN 3701G), and 19 mm lock washer (PN 4699G) under the 19
mm ex nut (PN 3704G) (see Figures 4 and 5).
Important:
Do not attach the 19 mm diameter bolt on the field side until the
Angle Strut is ready to be attached.
6. Attach the Flange Plates (PN 33464G) to center holes of the HBA Top Post 1 (PN 33462A)
flanges with a 10 mm diameter x 38 mm hex head bolt (PN 4261G) and 10 mm hex nut (PN
6405G) with a 10 mm flat washer (PN 4254G) under the bolt head and a 10 mm lock washer (PN
4258G) under the hex nut (PN 6405G) (see Figure 3).
Important:
There is no torque requirement for these bolts. They should be
tightened to a snug position. Do not over tighten these bolts.
Figure 3