63
Snap connector
Cable tie
Side slot
Rear view
Front view
7. Align the molex connection on the switch cable of
the harness assembly and connect to switch.
8. Mount the switch plate to the junction box with 2
screws provided. Note: Place the switch left or right
to suit the homeowner wishes.
9. Locate and secure the magnet plates using 2 ‘long’
screws provided.
10. Place and secure the
cover plate to the box
using 4 screws provided.
11. Feed the cable tie through the 2 side slots of the
battery cover assembly.
12. Position the battery holder to the rear face
and secure together with a cable tie. Note that
clearance is required for battery snap connection.
13. Make the snap
connection, load 4 AA
alkaline batteries into
the holder (included with
fi replace) then feed back
into the junction box
assembly.
Note: Do not put
batteries in the receiver,
only in the battery
holder by the wall switch.
14. Test the operation of the wall switch—see page 15.
INSTALLATION
QUALIFIED
INSTALLER