INSTALLER’S GUIDE
Page 41
Figure 54. Front surround top location
Figure 53. Front Surround Bottom
Location
Figure 52. Control linkage
disconnection
16.3
To Remove the Gas Shut-Off
Microswitch
See figures 49, 50 & 51.
The gas shut-off microswitch is stamped
V4NT9C2YCGPX or V4NT9C2YCAUX.
1.
Remove the bottom front cover and the fire
front casting.
2.
Remove the burner baffle by sliding
upward.
3.
Detach the microswitch cover by removing
one screw and pulling clear of the location
lug. See figure 49.
4.
Loosen the thermocouple nut to free the
microswitch leads and pull the leads clear
of the thermocouple interrupter block. See
figure 51.
5.
Detach the bridging bracket,
microswitch assembly and insulation pad
by removing two screws. See figure 50.
6.
Replace in the reverse order. When
refitting the leads to the interrupter block,
make sure that they are secured firmly to
give a good electrical contact.
16.4
To Remove the Fire Front
Surround
1.
Remove the bottom front cover and the
fire front casting.
2.
Remove the burner baffle by sliding
upward.
3.
Detach the control-linking bar from the
control pivot bracket by removing the
knurled screw, which joins the control
linking bar to the control pivot unit. See
figure 52.
4.
Remove the two screws and washers
securing the bottom of the front surround to
the sides of the hotbox. See figure 53.
5.
Make sure that the control linking bar
