INSTALLER’S AND OWNER’S GUIDE
Page 6
Figure 5.
Figure 4.
Method B – Wire Fix
The fixing kit includes a steel wire and eyebolt to attach
the heater to the back of the fireplace opening.
Mark the position for the eyebolt at the back of the
fireplace opening equal to the centre line of the heater
and at a height of 533 – 560mm. Drill, plug and screw in
the eyebolt (See figure 4).
Thread one end of the steel wire through the two holes in
the top flange, passing the wire through the eyebolt and
out through one of the opposite holes on the top flange
(See figure 4).
Locate the heater into the fireplace opening, then by
gently pulling the steel wire, gather up the excess until
the heater is firm.
Thread the wire back through the remaining hole to lock
the wire and heater in place
(See figure 4).
To prevent damage, when fixing through marble, ensure
that both the wallplug and screw pass freely through the
marble.
Secondary Screw fixing
If felt beneficial, the appliance can be additionally
secured by screws through the side flanges (See
figure 5).