INSTALLER’S AND OWNER’S GUIDE
Page 4
The heater must not be located under a fixed electrical socket, the socket must always be
accessible in order to disconnect the heater from the electrical supply for maintenance or
when replacing a lamp.
•
Important! This appliance must be earthed.
•
This heater is supplied with a 3 pin 13A fused rewireable plug with a 1mm
2
3 core
mains flex.
•
If the plug is not suitable for your socket, remove the plug and fit an appropriate plug.
If in doubt, consult a qualified electrician.
•
The wires in the mains lead are coloured in accordance with the following code: -
Green & Yellow = Earth
Blue = Neutral
Brown = Live
As the colours of the wires in the mains lead may not correspond with the coloured
markings identifying the terminals in your plug, fit the wires as follows: -
The wire which is coloured
Green & Yellow
must be connected to the terminal in the
plug which is marked with the letter
E
or by the earth symbol or coloured
Green
or
Green & Yellow.
The wire which is coloured
Blue
must be connected to the terminal which is marked with
the letter
N
or coloured
Black.
The wire which is coloured
Brown
must be connected to the terminal which is marked
with the letter
L
or coloured
Red.
If the mains cable is damaged then, for your safety, it must be replaced with an
approved cable by your authorised service agent or a qualified electrician.
The mains cable must be safely routed from the heater to an electrical socket. Provision
is made for left/right or rear cable entry, using one of the three cable guides at the base of
the heater. To relocate, open the appropriate latch on the cable guide and refit the mains
cable into the required position.
