INSTALLER’S GUIDE
Page 29
Figure 27. Ceramic Side Walls Installation
Figure 26. Ceramic Rear Wall
Installation
1 0 C E R A M I C W A L L S I N S T A L L A T I O N
1.
Fit the rear ceramic wall support bracket
to the rear of the convection box using two
screws. The “L” shaped section should be
on top with the two side tags underneath.
See figure 26.
2.
Fit the ceramic rear wall inside the “L”
bracket on the back face of the burner
compartment. Push the ceramic wall flat
against the back face of the burner
compartment. See figure 26.
3.
Remove four screws from the spillage
plate sides (See figure
27).
4.
Remove the spillage
plate by lifting it
forward.
5.
Fit the ceramic side
walls against the side
faces of the burner
compartment. The
bottom edges of the
walls should rest in the
ledges at the sides of the
firebox. Slide them in
from the front and
ensure that the touch the
rear wall. The friction
between the side walls
and the rear wall should
hold the side walls in
position. See figure 27.
6.
Re-fit the spillage
plate. Be careful not to
damage the edges of the
side walls. The spillage
plate will hold the side walls in place.