INSTALLER’S GUIDE
Page 19
Figure 10. Pilot ignition
system
Figure 9. Slider control
Figure 8. Battery Fitting
5 I G N I T I O N C H E C K
Before attempting to install, it is worth
checking that the electronic ignition
system performs satisfactorily.
●
Fit the battery to the ignition block
located below the burner tray at the left
side (see figure 8). The positive
terminal (+) is to the bottom as you
insert.
Depress the slider as far as it will go.
This should close the ignition circuit.
Sparks should be seen tracking from
the electrode pin to the thermocouple
tip. See figure 9.
●
If there are no sparks make the following
checks.
a.
Check condition of battery and that it is
correctly fitted.
b.
Check spark gap between electrode wire
and thermocouple tip. See figure 10.
c.
If a & b are satisfactory, check the
ignition circuit and components - see the
servicing section in this manual.