Fitting the firefront and ash pan.
1.
Remove the firefront and ash pan from the
packaging.
2.
The rear of the firefront may be fitted with hanging
screws or they may be supplied in the firefront
packaging. Where they are not already fitted insert
them into the lower holes on both sides of the
firefront. The distance between the firefront and the
underside of the screw heads should be
approximately 10mm. The screws can be adjusted to
obtain the required fit (See figure 30).
3.
Hang the firefront on the slots on the heater (See
figure 31).
4.
Position the ash pan beneath the firefront.
Fitting the louvre assembly.
Please take care when attaching or
removing the louvre assembly to avoid
marking the fascia surface.
1.
Locate the louvre assembly onto the
brackets at the top of the fascia casting (See
figure 32).
©
Baxi Heating U.K. Limited 2011.
Page 34
Figure 32.
Figure 31.
Figure 30.
INSTALLER GUIDE
