INSTALLER’S GUIDE
Page
15
•
Using a 6mm masonry drill, drill into the hearth at the marked positions.
•
Insert the supplied plastic screw
plugs.
•
Replace the burner assembly
and fix in position using the
wood screws provided (See
figure 7)
Method 2.
•
Place the burner assembly in
the position (See figure 8).
•
Mark on the fireplace floor the
position of one of the fixing
holes in the bracket that is
attached to the rear of the front
leg. There are two holes in this
bracket to allow the soundest
and most even surface of the
fireplace floor to be used for
fixing.
•
Remove the burner assembly.
•
Using a 6mm masonry drill,
drill into the hearth at the
marked position.
•
Insert the supplied screw
plug.
•
Remove the fixing bracket
from the front leg by undoing
the screw.
•
Place the bracket in position
on the fireplace floor and fix
in position using the
woodscrew provided.
•
Place the burner assembly back in position and attach to the bracket by refitting
the screw.
Figure 8. Locating the burner (Method 2)
Figure 7. Locating the burner (Method 1)
