INSTALLER’S GUIDE
Page
17
Check reference pressure.
The appliance is pre-set to give the correct heat input at the inlet pressure shown
within Appliance data section of this manual. No further adjustment is necessary.
The burner pressure should be checked by fitting a pressure gauge at the test point
accessible to the right of the control knob (See figure 9). The pressure should be
checked with the appliance alight and the control set at ‘HIGH’. After checking the
pressure, turn off the appliance. Remove the pressure gauge and replace the test
point sealing screw. Re-light the appliance. Turn to ‘HIGH’ position and test
around the sealing screw for gas soundness using a suitable leak detection fluid.
Figure 9. Pressure test point position