7
5.1.4
Install the supply pipe to run through the thick line
marked “
Supply pipe entry”
and up to the inlet elbow
position.
Note that the centre of the appliance inlet elbow is
18mm above the fireplace floor. The inlet elbow
should be removed from the appliance and fitted to
the supply pipe at this stage.
Remove the template.
Note: If the supply pipe
connection is to be from the right side, keep the
template, It will be useful for bending the pipe later on
(Section 8.4)
5.2
SIDE SUPPLY PIPE CONNECTION
The appliance is designed to allow a side supply pipe
to run in front of the front surround and through a
cut- out at either rear bottom corner of the fire front
casting. For side connection, final installation of the
supply pipe should be left until the appliance is
installed in the fireplace.
6.
PREPARING APPLIANCE FOR INSTALLATION
6.1
Remove the two screws securing the bottom of the
front surround to the sides of the convection box.
Raise the front surround to allow the retaining lugs
at the top to clear the slots in the convection box
hood and then lift clear (see figure 4).
6.2
Detach the burner unit from the convection box by
removing three screws (see figure 5). Lift the burner
unit clear.
6.3
Fit the two small "U" section seals to the bottom
edges of the convection box side flanges (see fig.6).
Fig. 4 Front surround removal
Fig. 5 Burner attachment points
Fig. 6 “U” seal positions
