INSTALLER’S GUIDE
Page 35
in position. Make sure that the centre section of the combination plaque is between the two
plaques. If there is any play between the plaques and the end retaining flanges, push the
plaques firmly to the left squeezing the centre section of the combination gasket between
the two plaques. Any gap should be between the right side of the plaque and the right side
retaining flange.
8.
Fit the front and rear plaque clamping strips. Make sure that the plaques are as far to the
left as possible. .
It is important that the left side plaque is accurately positioned so that it
has the correct relationship to the pilot.
Fully tighten the clamping strips.
9.
Refit the coals as described in section 12 of this manual. Refit the bottom castings.
16.14
To Remove the Appliance from the Fireplace
1.
Remove the burner unit - See section 16.6.
2.
Installations without spacing unit 617K
If the fire retention is as method 1 (See section 8.1 of installation instructions), remove
the screws.
If the fire retention is as method 2 (See section 8.2 of installation instructions), slacken
the hexagonal adjusters on the cable retainers and unscrew the thumbscrews to release
the cables.
3.
Installations with spacing unit 617K
Remove the nine screws securing the appliance to the front of the spacer unit.
If the appliance is attached to the fireplace floor, remove the two fixing screws.
4.
Refit as described in the relevant installation sections. Make sure gas soundness,
sealing, spillage test and performance are satisfactory.
