INSTALLER’S GUIDE
Page 30
Fig. 45 Front Surround Bottom
Location
Fig. 46 Front surround top location
Fig. 47 Control slide & button
fixings
3.
Remove the
two screws
securing the
bottom of the
front surround to
the sides of the
convection box.
See fig. 45.
4.
Make sure
that the control
linking bar has
been detached
(See 2 above)
.
Carefully lift the surround unit upwards
to clear the upper retaining brackets on the convection
box - See figure 46. Pull the surround clear and place
carefully aside.
5.
Refit in the reverse order. Make sure that the
surround is properly located over the upper retaining
brackets. See section 11 of this manual for detailed
fitting instructions.
16.4
To Replace the Control Slide Unit
1.
Remove the front surround - See section 16.3.
2.
Detach the slide unit by removing two screws
securing the plastic slide mechanism to the rear of the
front surround – See figure 47.
3.
Replace in the reverse order.
16.5
To Replace the Control Slide Button
1.
Remove the front surround – See section 16.4.
2.
Detach the slide button by removing two screws – See figure 47.
3.
Replace in the reverse order.
16.6
To Remove the Burner Unit
1.
Remove the bottom front and fire front castings and the front surround - See section
16.3.
2.
Remove the loose coals, the front coal and the base coal.
3.
Remove the ceramic side and rear walls.
4.
Support the inlet isolating elbow to avoid straining the pipework and disconnect the
appliance from the elbow.
