9. HOTBOX INSTALLATION
9.1 Method 1 - Front fixing to fireplace surround.
1.
Make sure that the fireplace front surround area is sound enough to take the fibre /
wooden wall plugs and wood screws. If
necessary, make sound with suitable
cement.
2.
Place the hotbox centrally in the fireplace
in the position in which it is to be
permanently installed. If a concealed
connection is being used, insert the hotbox
into the fireplace feeding the supply pipe
through the pierced hole in the rear
grommet.
3.
Mark the fireplace front surround through
the four fixing holes in the side flanges of
the hotbox (See figure 16).
4.
Remove the hotbox. Drill four holes in the
fireplace front surround at the
marked positions using a
suitably sizes masonry drill.
5.
Insert a fibre / wooden wall
plug into each hole.
6.
Place the hotbox back in
position in the fireplace.
7.
Fit a wood screw through
each hole in the hotbox flanges
and tighten to seal the box to
the fireplace surround.
9.2 Method 2 - Cable
retention and floor fixing.
1.
Make sure that the relevant
areas at the fireplace back or
floor are sound enough to take
the eyebolts and screws. If
these areas have deteriorated
due to prolonged use they
should be made sound with
suitable cement.
2.
Drill four holes in the rear
wall of the fireplace for the
fibre / wooden wall plugs. The
Page 24
©
Baxi Heating U.K. Limited 2009.
Figure 17. Eyebolt positions
Figure 16. Front fixing
INSTALLER GUIDE