11. CERAMIC WALLS INSTALLATION
1.
Fit the ceramic rear wall inside the “L”
bracket on the back face of the burner
compartment. Push the ceramic wall flat
against the back face of the burner
compartment (See figure 27).
2.
Fit the ceramic side walls against the side
faces of the burner compartment. The
bottom edges of the walls should rest in the
ledges at the sides of the firebox. Slide
them in from the front and ensure that they
touch the rear wall. Be
careful not to damage the
edges of the side walls
(See figure 28).
12. FITTING THE FASCIA
Before fitting the fascia ensure that the information in the WARRANTY AND
SERVICE section of the OWNER GUIDE are complete (See last pages of the
OWNER guide).
1.
Carefully lift the fascia. Place the fascia
against the fireplace front surface so that the
two retaining plates at the back of the fascia are
directly above the two upper retaining brackets
at the top of the hotbox. Lower the fascia unit
making sure that the retaining plates locate fully
into the brackets on the hotbox (See figure 29).
2.
Secure the bottom of the fascia using the two
screws supplied.
Page 30
©
Baxi Heating U.K. Limited 2009.
Figure 28. Ceramic side walls installation
Figure 27. Ceramic rear wall installation
Figure 29. Fascia location (Fascia
may differ from that shown)
INSTALLER GUIDE