b Remove the pin from the comb harness by
unscrewing one of the two nuts.
c The movement is transmitted to the comb
using a mesh retained by a steel fork. Through
a screwdriver, pull the steel fork upwards.
d Pay attention to the spacer on the mesh. Pull
the knit and then the comb.
Reassemble the new comb by repeating the
dismantling phases in the reverse direction.
Fuse replacement:
In case of short circuits, the electric system is
protected by a fuse located inside the fuse holder
(10 Fig.A) downstream of the positive terminal.
To replace it, open the fuse holder, remove the
old fuse, install a new one and close the fuse
holder again.
N.B. The tripping current of the new fuse must
be the same of the old fuse.
Cleaning
Clean all parts of the machine with a damp cloth
and then dry it completely. Do not use aggressive
detergents which may damage the plastic parts.
STORAGE
1) Carry out careful maintenance and cleaning
of the entire tool as specified
in the paragraphs above.
2) Where to store the tool:
- Out of reach of children
- In a stable and safe place
- In a warm, dry place
- Far from direct sunlight
Do not store in plastic bags as humidity may
form.
TROUBLESHOOTING
The tool does not work:
- When the battery is flat (recharge the battery)
- When the terminals are not properly connected
(invert polarities)
- When the fuse has tripped (replace the fuse)
The tool does not have the appropriate power:
- When the battery is flat (recharge)
DEMOLITION:
I Electric and electronic waste may contain
potentially hazardous substances for the envi-
ronment and human health. It should therefore
not be disposed of with domestic waste, but
by means of differentiated collection at specific
centres or returned to the vendor in the event
of purchasing a new identical tool. The illegal
disposal of such equipment may result in pro-
secution to the full extent of the law.
WARRANTY
The product is protected by law against non-
compliance with the declared characteristics
provided it is used only in the manner described
in the instructions, it has not been tampered with
in any way, it has been stored properly, has been
repaired by authorized and, where applicable,
have been used only original spare parts.
In the case of industrial or professional use or
when using such a guarantee is valid for 12
months.
To issue a claim under warranty you must
present proof of purchase to your dealer or
authorized service center.
