- 14 -
SWITCHING OFF
1) To stop the machine, lift the cover and press
the switch to the OFF “O” position (switched
off).
2) Ensure that persons and animals are kept
away from the machine until it has completely
stopped. It is also possible to switch the
machine off with the lid closed by pressing the
red mushroom head button: to open, push up
the red mushroom head button.
The engine and the moving parts will continue
to run for a few seconds after the machine is
switched off.
When not using the machine, turn it off and
disconnect the plug from the socket.
WARNINGS AND TIPS FOR USING THE
MACHINE
Regularly check that the dust collector functions
correctly; if it is stalled or clogged, switch it
off immediately. To ensure the wood chips are
vacuumed immediately and the work surface
of the machine tool is kept clean, switch on the
dust collector before switching on the machine
tool. For the same reason, switch off the dust
collector after switching off the machine tool.
To ensure optimal performance of the machine,
make sure that it is in a well ventilated area,
to allow an efficient release of air from the air
filter bag.
Regularly clean the air filter bag to allow an
efficient release of air and obtain optimal
performance.
Position the machine in such a way that the hose
connected to the machine tool is as straight as
possible, without kinks and of a limited length,
but sufficiently long to keep a safety distance
between the two machines.
Empty the collection bag once it’s filled to about
4/5 of the volume (see Fig. A).
ENGINE PROTECTION
The machine has a safety device that protects
the engine, which automatically intervenes
if needed. In case of overheating, the engine
switches off; before restarting the machine,
improve ventilation of the area and wait a few
minutes.
MAINTENANCE
!
!
WARNING! Always unplug the tool from the
mains socket before proceeding with any sort
of inspection or maintenance jobs.
-
Clean and maintain your machine regularly, to
ensure that it remains perfectly efficient and
has a long working life.
- Clean the machine using a cloth or a brush
only.
- Do not spray or wet the machine with water.
- Do not use any abrasive detergents or solvents
as these may damage the machine beyond
repair.
- Regularly wash the air filter bag with cold water
and soap; dry thoroughly before replacing it on
the machine
.
TROUBLESHOOTING
WARNING! UNPLUG THE TOOL FROM THE MAINS
SOCKET BEFORE ANY OPERATION
.
If the machine does not start:
Verify no
thermal protection has tripped . Check
that all electrical connections are properly
connected to the mains; check that the
cutout box hasn’t tripped; check the electrical
system of the building; check that the suction
impeller is not blocked by a piece of wood
that is too large. If the problem persists
following these checks, then the problem
could be in the machine itself. Have an
authorised service centre check it out.
If the machine does not have good suction:
check that the collection bag is not full
over the maximum level; check that the air
filter bag is not dirty; check that the hose
connected to the machine tool is not kinked,
broken, or badly fastened on either end;
check that the dust suction connection is
not clogged.
