Проверил: Р.Ч./24.03.2015г
Maintenance schedule
12 hours of
use
24hours
of use
36hours
of use
Air filter
Clean
clean
replace
Spark plug
check
Clean
replace
Engine oil
check
replace
Check
1) Open the wheel cover and find loose direction on the wheel bolt (Fig.f1).
2) After using sleeve to loosen bolt and removing wheels, there are three position holes to adjust cutting height. The higher
position hole, the lower cutting height (Fig.f2 f3).
3) Tighten bolt against the loose direction and cover the wheel.
MAINTENANCE
1. Cleaning
To ensure the best performance of your lawnmower, it is important to keep it clean. Always clean your lawnmower
immediately after use. Do not allow grass cuttings and other debris to become dry and hard on
any of the mower surface.
This will directly affect the cutting and grass collection performance. Make sure that the underside of the lawnmower deck
is clean and clear.
Ensure the discharge chute and grass discharge flap are clean. The grass bag must always be emptied after use. Make
sure that the exterior of the engine is clear of all debris, cuttings and dirt.
2. Spark plug
1) Once the engine has cooled, remove the spark plug cap and get spark plug out using the socket spanner supplied
(Fig.g1).
2) Clean the plug with a wire brush.
3) Using a feeler gauge, set the gap to 0.75mm .
4) Install the spark plug carefully by hand to avoid cross-threading.
5) After the spark plug is seated, tighten
with spanner to compress the washer.
3. Air filter
Fig.g1
0.75mm
Fig.f3
