Valeport rapidPro CTD, Operating Manual

Page: 26 / 36

© 2019 Valeport Ltd
0660907a - rapidPro Operating Manual
Page 26
Safety Compliance
In order to fulfill the safety standard EN 60950-1, the unit must be supplied by a limited power source.
FCC Compliance
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
·
Reorient or relocate the receiving antenna.
·
Increase the separation between the equipment and receiver.
·
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The ODIN-W2 module is for OEM integrations only. The end-user product will be professionally installed in such a
manner that only the authorized antennas are used.
Any changes or modifications NOT explicitly APPROVED by u-blox could cause the module to cease to comply
with FCC rules and thus void the user's authority to operate the equipment.
Cautions
Any changes or modification could cause the module to cease to comply with FCC rules part 15 and thus
void the user's authority to operate the equipment.
In case of absence of information to transmit or operational failure the module types ODIN-W2 will
automatically discontinue transmission.
Labeling requirements for end product
For an end product using the ODIN-W2 modules there must be a label containing, at least, the following
information:
This device contains
FCC ID: PVH0965
IC: 5325A-0965
3.1.3. Bluetooth Qualification Information
The ODIN-W2 series modules have been qualified according to the Bluetooth 4.0 specification.
The ODIN-W2 series module is Bluetooth listed with Declaration ID D028207. For an end product with ODIN-W2
integrated no further qualification is required.