Function menu
Compa II series
58 Operating
manual
07.15
Press key
to arrive the next menu item.
Before the end of transfer ribbon, a signal is send by the control
output.
Setting of transfer ribbon advance warning diameter.
In case you enter a value in mm then a signal appears via control
output when reaching this diameter (measured at transfer ribbon roll).
Setting of the reduced print speed. This can be set in the limits of the
normal print speed. Additionally there are the following settings:
−
: No reduced print speed
0
: Printer stops at reaching the warning diameter and indicates 'ribbon
error'.
Press key
to arrive the next menu item.
Indication of value in 1/100 mm.
After replacing the printhead - the print cannot be continued at the
same position on the label, the difference can be corrected.
NOTICE!
The value for zero point adjustment is set ex works. After
replacing the printhead, only service personnel are allowed to
set this value anew.
Press key
to arrive the next menu item.
Indication of print layout correction in percent.
By mechanical influences (e.g. label roll size) the print layout can be
printed increased and reduced to its original size.
Value range: +10.0% …
−
10.0%
6.12 Main menu
Switch on the label printer and the display shows the main menu. The
main menu shows information such as printer type, current date and
time, version number of firmware and the used FPGA.
The selected display is shown for a short time, then the indication
returns to the first information.
Press key
to arrive the next information display.
Transfer ribbon
advance warning
Warning diameter
Reduced speed (v)
Zero point adjustment
Print /
−
