Loading media
Compa II series
32 Operating
manual
07.15
Figure 12
1. Loosen knurled screw (1), turn guiding (2) upwards and move it to
the outside as far as possible.
2. Insert label roll on the roll holder so you can see the side from
above which can be printed on.
3. Unwind a longer label strip:
For tear-off and cutter mode: approx. 40 cm
4. Move label roll as far as it will go to the housing wall.
5. Turn guiding (2) upwards to the roll holder (3) and push it towards
the label roll to decelerate it when unwinding.
6. Tighten knurled screw (1).
1. Turn lever (5) anticlockwise to lift up the printhead.
2. Push label guiding on deviating shaft (4) all the way out.
3. Guide label material below the deviating shaft (4) and the label
photocell so it leaves the print unit between rotating and linear
cutter edge.
4. Push label guiding on deviating shaft (4) against the outer edge of
the label material.
Loading label roll in
cutter mode
Inserting label material
into print unit
